cn1519802753ynna@126.com 86-731-89903933

  • Phone

    86-731-89903933

  • Address

    Room 1003, Building 22, Zhongcheng Lijinxiangshan District, No. 239, Part II, Wanjiali Middle Road, Yuhua Area, Changsha, Hunan, China (Mainland)

  • E-mail

    k@waimaotong.com

LatestProducts
Hot Sell
Home > Sell
special steel High Precision Machining Propeller Shaft
special steel High Precision Machining Propeller Shaft
special steel High Precision Machining Propeller Shaft
special steel High Precision Machining Propeller Shaft
special steel High Precision Machining Propeller Shaft

special steel High Precision Machining Propeller Shaft

special steel High Precision Machining Propeller Shaft,Metallurgy, Chemicals,Minerals & Metallurgy,Steel
INQUIRY PRECISE INQUIRY
Description

Overview
Quick Details
Steel Grade:
Carbon Steel
Standard:
AISI, ASTM, BS, DIN, GB, JIS
Dimensions:
Customised
Place of Origin:
China (Mainland)
Brand Name:
carbon steel shaft
Model Number:
35#
Technique:
Forged
Application:
shaft
Alloy Or Not:
Non-alloy
Type:
Carbon Steel Bar
Grade:
35#
Product Name:
Forged Propeller Shaft
Material:
Carbon Steel
Delivery condition:
Hot Forged +A/N/QT
Surface:
Machined
Surface treatment:
Roungh Turned
Shape:
Round Section
Name:
Forged shaft
Certificate:
ISO BV SGS GL LR ABS CCS
Length:
customlized
Supply Ability
Supply Ability:
100 Set/Sets per Month
Packaging & Delivery
Packaging Details
Forged steel forgings,Customised
Port
Shanghai

It is used to connect the major engine and stern shaft

35# forged steel

1.The chemical composition of forging shall be to comply with the following requirements:

special steel High Precision Machining Propeller Shaft
 
 

Cr, Mo, Ni, Cu are considered as residuals elements unless limit content shown on above table.

2.The mechanical properties of forgings after heat treatment should be to comply with the requirements

 

3. Shaft shall be normalizing and tempered (the tempering temperature should be not less than 550℃) after rough machining in order to eliminate inner stress. and Non destructive test should be done according to requirement.

4. The surface of shaft shall be no scar, nick, sharp angle, burr; and the rounded corner should be smooth.

Related Sell